create an automation clip in fl studio 12

Go the Menu bar at the top left corner and click “TOOLS”. If you’re a fan of certain 3rd party plug-in or synthesizer and you do not know how to automation the knobs within the plug-in, then this tip is for youįor this example, I am going to automate the filter cut-off knob within Sylenth1.įirst, you click and drag the filter cut-off knob a little to let FL Studio know that you’re adjusting the knob. The Low Pass Filter automation for Synth A is now controlling cut-off knob for Synth B’s Low Pass Filter as well. Make sure to remove the “Remove conflicts” function.Ĭlick “Accept” and you’re done. In the internal controller section, select the Low Pass Filter automation for Synth A. I can help you to avoid thatįirst you go to the filter plug-in of Synth B and right click at the Cut-off Knob. You’ll think that you have to write the automation all over again. And you decide to layer Synth A with Synth B. Let’s say that you have set up an automation for Synth A and you’re happy with the result. To change the shape of the automation, simply right click one automation point and you’ll have the options as shown in the picture above. In this article, I am going to show TOP 5 tips to boost your workflow while you’re dealing with automations within FL Studio.Īre you tired of using the same shape or mode for your automation? FL Studio actually offers 13 kinds of automation shapes to help you spice up your tracks even more. However, writing automation can be a little frustrating if you are not doing it right in your DAW. If you have written quite a few of tracks in your journey as a music producer, you’ll know that automation is one of the most important elements which can make wonders to your song.

Create an automation clip in fl studio 12